Veris-industries V100DC Install Manuel d'utilisateur télécharger pdf

Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.

REL AYS

INSTALLATION GUIDE

10A SPDT Enclosed Relay

10-30 VDC Coil

Installer’s Speciﬁcations

Operating Temperature -34°C to 60°C (-29° to 140°F)

Operating Humidity 10-90% non condensing

Expected Relay Life Electrical (at rated current): 100,000 cycles

Mechanical (unpowered): 10,000,000 cycles

Relay Status LED ON=energized

Wire Specications:

Lead Length 14” (356mm) min.

Gauge UL1015; Coil: 18 AWG; Contacts: 16 AWG

Insulation Class 600 VAC RMS

Agency Approvals UL508 enclosed device listing

V100DC

DIMENSIONS

NOTICE

• This product is not intended for life or safety applications.

• Do not install this product in hazardous or classiﬁed locations.

• The installer is responsible for conformance to all applicable codes.

• Mount this product inside a suitable ﬁre and electrical enclosure.

INSTALLATION

Disconnect and lock out all power sources before beginning the

installation.

1. Using the threaded nipple, connect the relay to the desired enclosure through a

knock out hole.

2. Secure with the conduit nut provided.

3. Connect Coil:

• Choose the coil common lead (white with yellow stripe) and connect it to

the (-) source termination point.

• Choose the low voltage (10-30 VAC/DC, white with blue stripe) lead, and

connect it to the (+) source termination point.*

4. Connect Relay Contacts:

• Choose the relay common wire (yellow) and connect to switched load.

• Choose the relay N.O. (orange) and/or* N.C. (blue) lead and connect to

switched load.

5. Secure the enclosure and reconnect power.

* Isolate or insulate all non-terminated wires according to local electrical code requirements, i.e.

wire nut.

1.6"

(41 mm)

1.7"

(43 mm)

1/2" NPT Nipple

1.8"

(46 mm)

2.9"

(74 mm)

2.8"

(71 mm)

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH

• Follow safe electrical work practices.

See NFPA 70E in the USA, or applicable local codes.

• This equipment must only be installed and serviced by qualied electrical personnel.

• Read, understand and follow the instructions before installing this product.

• Turn o all power supplying equipment before working on or inside the equipment.

• Use a properly rated voltage sensing device to conrm power is o.

DO NOT DEPEND ON THIS PRODUCT FOR VOLTAGE INDICATION

Failure to follow these instructions will result in death or serious injury.

DANGER

1 2

Résumé du contenu

Page 1 - 10-30 VDC Coil

Page 2 - CONTACT RATINGS

Commentaires sur ces manuels

Pas de commentaire

Veris-industries V100DC Install Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Veris-industries V100DC Install. Veris Industries V100DC Install User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Veris-industries V100DC Install