Veris-industries V101 Install Manuel d'utilisateur télécharger pdf

Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.

REL AYS

INSTALLATION GUIDE

10A SPST Enclosed Relay With HOA Switch

Installer’s Speciﬁcations

Operating Temperature -40° to 55°C (-40° to 131°F)

Operating Humidity 10-90% RH, non-condensing

Expected Relay Life Electrical (@ rated current) 100,000 cycles;

Mechanical (unpowered) 10,000,000 cycles

Relay Status LED ON=energized

Wire Specications:

Lead Length 14” (356mm) min.

Gauge UL1015; Coil: 18AWG; Contacts: 16AWG

Insulation Class 600VAC RMS

Agency Approvals UL508 enclosed device listing, pollution degree 2

V10 1

DIMENSIONS

NOTICE

• This product is not intended for life or safety applications.

• Do not install this product in hazardous or classiﬁed locations.

• The installer is responsible for conformance to all applicable codes.

• Mount this product inside a suitable ﬁre and electrical enclosure.

INSTALLATION

Disconnect and lock out all power sources before beginning the

installation.

1. Using the threaded nipple, connect the relay to the desired enclosure through a

knock out hole.

2. Secure with the conduit nut provided.

3. Connect coil wires:

• Choose the coil common lead (white with yellow stripe) and connect it to

the common (-) source termination point.

• Choose either the low voltage (10-30VAC/DC, white with blue stripe) or

high voltage (120VAC, white with black stripe) lead, depending on the

application requirements, and connect it to the (+) source termination

point.*

NOTE: When connecting the control side of this device (#18 wires) to power

line circuits, provide current limiting at 7 amps max.

4. Connect relay contacts:

• Choose the two orange wires (N.O. contact) and connect to the switched

load.

5. Secure the enclosure and reconnect power.

* Isolate or insulate all non-terminated wires according to local electrical code requirements, i.e.

wire nut.

2.0"

(52 mm)

2.5"

(64 mm)

3/4" NPT Nipple

2.3"

(59 mm)

4.0"

(103 mm)

3.8"

(97 mm)

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH

• Follow safe electrical work practices.

See NFPA 70E in the USA, or applicable local codes.

• This equipment must only be installed and serviced by qualied electrical personnel.

• Read, understand and follow the instructions before installing this product.

• Turn o all power supplying equipment before working on or inside the equipment.

• Use a properly rated voltage sensing device to conrm power is o.

DO NOT DEPEND ON THIS PRODUCT FOR VOLTAGE INDICATION

Failure to follow these instructions will result in death or serious injury.

DANGER

1 2

Résumé du contenu

Page 1 - INSTALLATION GUIDE

Page 2 - CONTACT RATINGS

Commentaires sur ces manuels

Pas de commentaire

Veris-industries V101 Install Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Veris-industries V101 Install. Veris Industries V101 Install User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Veris-industries V101 Install