Veris-industries H8126-CB Install Manuel d'utilisateur télécharger pdf

VERIS INDUSTRIES

™

POWER MONITORING

INSTALLATION GUIDE

Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.

H8126 - CB

N2 Communication Board for the

H81xx Energy Meter

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH

• Follow safe electrical work practices. See NFPA 70E in the USA, or applicable local codes.

• This equipment must only be installed and serviced by qualiﬁed electrical personnel.

• Read, understand and follow the instructions before installing this product.

• Turn oﬀ all power supplying equipment before working on or inside the equipment.

• Use a properly rated voltage sensing device to conﬁrm power is oﬀ.

DO NOT DEPEND ON THIS PRODUCT FOR VOLTAGE INDICATION

• Only install this product on insulated conductors.

Failure to follow these instructions will result in death or serious injury.

DANGER

NOTICE

• This product is not intended for life or safety applications.

• Do not install this product in hazardous or classiﬁed locations.

• The installer is responsible for conformance to all applicable codes.

• Mount this product inside a suitable ﬁre and electrical enclosure.

FCC PART 15 INFORMATION

NOTE: This equipment has been tested by the manufacturer and found

to comply with the limits for a class A digital device, pursuant to part

15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is

operated in a commercial environment. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in

a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at his own expense.

Modiﬁcations to this product without the express authorization of

Veris Industries nullify this statement.

Product IdentIfIcatIon

H8126-CB N2 Communication Board

quIck Install

Disconnect power to the meter.1.

Set the DIP switches for appropriate network addressing.2.

Wire the communications terminals for 2-wire or 4-wire communication.3.

Disconnect power to the energy meter. Discharge static using an anti-static or 4.

grounding strap.

Still using the anti-static strap, install the H8126-CB into the slot in the energy 5.

meter until the board clicks into place.

Restore power to the meter.6.

H8126 - CB

Observe handling precautions for static sensitive

devices to avoid damage to the circuitry which

would not be covered under the factory warranty.

1 2 3 4 5 6 7 8 9 10

Résumé du contenu

Page 1 - H8126 - CB

Page 2

Page 3

Page 4

Page 5 - H8126-CB

Page 6

Page 7

Page 8

Page 9

Page 10 - INSTALLATION GUIDE

Commentaires sur ces manuels

Pas de commentaire

Veris-industries H8126-CB Install Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Veris-industries H8126-CB Install. Veris Industries H8126-CB Install User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Veris-industries H8126-CB Install